Oil Pump Replacing on Acura?

Oil Pump
REMOVAL & INSTALLATION: ---

The details are as follows :----

1. Before servicing the vehicle, refer to the precautions section.
2. Drain the engine oil.
3. Remove or disconnect the following: 
   
   
   Negative battery cable

   Accessory drive belts

   Front cover

   Timing belt

   Timing belt idler pulley

   Crankshaft Position (CKP) sensor

   Crankshaft timing sprocket

   Variable Valve Timing and Valve Lift Electronic Control (VTEC) solenoid valve connector

   Oil filter adapter

   Oil pan

   Oil pump pickup tube

   Oil pump 
   
   

   

   Fig. Exploded view of the oil pump assembly

To install:

NOTE

Use new gaskets and O-ring seals for assembly.

1. Apply liquid gasket to the oil pump and to the bolt hole threads.
2. Install or connect the following:
   
   
   Oil pump. Tighten the bolts to 105 inch lbs. (12 Nm).

   Oil pump pickup tube. Tighten the bolts to 105 inch lbs. (12 Nm).

   Oil pan

   Oil filter adapter

   VTEC solenoid valve connector

   Crankshaft timing sprocket

   CKP sensor

   Timing belt idler pulley

   Timing belt

   Front cover

   Accessory drive belts

   Negative battery cable
3. Fill the crankcase to the correct level.
4. Start the engine and check for leaks.

This will help.

Thanks.

FOR MORE HELP GO TO: ---

Car repair guide?

http://technoanswers.blogspot.in/2012/03/car-repair-guide.html