How to replace Blower motor On 2007 Ford Taurus?

The procedure is similar for 2006 and 2007 Ford Taurus.

Blower motor Removal & Installation details are as follows:---

1. Before servicing the vehicle, refer to the Precautions section.
2. Disconnect the negative battery cable.
3. Disengage the instrument panel insulator from the instrument panel.
4. Detach the wiring connector at the blower motor.
5. Unsnap the instrument panel upper finish panel from the instrument panel.
6. On vehicles equipped with autolamp, Detach the electrical connector from the light sensor amplifier.
7. Unsnap and remove the instrument panel finish end panel from the right side of the instrument panel.
8. Remove the 3 screws retaining the instrument panel to the upper cowl top panel.
9. Remove the 2 screws at each right side of the instrument panel.
10. Remove the 3 screws retaining the blower motor to the evaporator housing.
11. Pull the instrument panel away from the cowl and remove the blower motor from the A/C evaporator housing.
12. If required, separate the blower motor wheel from the blower motor by removing the retainer from the blower motor shaft and sliding the blower motor wheel off the blower motor shaft.
    
    
    

    

    Fig. The blower motor-to-evaporator housing mounting
    
    
    
    

    

    Fig. the blower wheel is held to the motor by a retaining clip

To install:

1. If the blower motor wheel was removed, align the flats on the inside diameter of the wheel hub with the flat surface on the blower motor shaft and slide the blower motor wheel onto the blower motor shaft. Install a new blower motor wheel retainer onto the shaft.
2. Install the blower motor and wheel assembly into the evaporator housing and firmly tighten the 3 retaining screws.
3. Reposition the instrument panel and install the 2 screws at each right side of the instrument panel.
4. Install the 3 screws retaining the instrument panel to the upper cowl top panel.
5. Install the instrument panel finish end panel to the right side of the instrument panel.
6. On vehicles equipped with autolamp, Attach the electrical connector to the light sensor amplifier.
7. Snap the instrument panel upper finish panel to the instrument panel.
8. Attach the wiring connector at the blower motor.
9. Engage the instrument panel insulator to the instrument panel.
10. Connect the negative battery cable. Check for proper blower motor operation.

This will help.
Thanks.

FOR MORE HELP GO TO: ---

Car repair guide?

http://technoanswers.blogspot.in/2012/03/car-repair-guide.html