Front Crankshaft Seal Removal on Acura?

Front Crankshaft Seal
REMOVAL & INSTALLATION: ---

The details are as follows :----

1. Before servicing the vehicle, refer to the precautions section.
2. Remove or disconnect the following: 
   
   
   Negative battery cable

   Accessory drive belts

   Side engine mount

   Valve cover

   Crankshaft pulley

   Front cover

   Balance shaft belt, if equipped

   Timing belt

   Top Dead Center (TDC) sensor, if equipped

   Crankshaft timing sprocket

   Front crankshaft seal 
   
   

   

   Fig. Front crankshaft seal installation

To install:

1. Lubricate the crankshaft seal lip with grease prior to installation.
2. Install the front crankshaft seal so that it is flush with the surface of the oil pump housing.
3. Install or connect the following:
   
   
   Crankshaft timing sprocket

   Top Dead Center (TDC) sensor, if equipped

   Timing belt

   Balance shaft belt, if equipped

   Front cover

   Crankshaft pulley. Tighten the bolt to 181 ft. lbs. (245 Nm) on 2001-02 models, or 47 ft. lbs. (64 Nm) plus an additional 60 degrees on 2003-06 models.

   Valve cover

   Side engine mount

   Accessory drive belts

   Negative battery cable
4. Check the engine oil level and add if necessary.
5. Start the engine and check for leaks.

This will help.

Thanks.

FOR MORE HELP GO TO: ---

Car repair guide?

http://technoanswers.blogspot.in/2012/03/car-repair-guide.html