@

Sunday, February 26, 2012

Where is the pcv valve located on 2007 Duratec ford focus xr5?

its behind/under the intake manifold, and its a nasty job changing it out.If you are under the front looking into the engine compartment, you can see it easier than trying to find it looking under the hood. The problem is reaching it.

you have to remove the intake manifold to get to it.
 most models have the PCV valve located in the crankcase ventilation oil seperator, which is mounted lower on the engine.


you need to raise the vehicle, put it on jackstands, remove the splash-shield, remove the intake manifold for access to the PCV valve, disconnect the PCV hose on the valve at the seperator, Push in the two tabs, and twist the PCV valve out.

As per service manual it says that on all models, SPI/Zetec/Duratec to test the valve, shake it vigorously. If it doesn't rattle, replace the valve.
It's the blue thing and is behind the intake manifold.

See the image shown below :---



One more image:---





This will help.
Thanks.

See below latest solved car problems :---


How to replace Drive Shaft bearing on Toyota pick up?

http://schematicsdiagram.blogspot.in/2012/02/how-to-replace-drive-shaft-bearing-on.html

Car suddenly died and won’t start?

http://technoanswers.blogspot.in/2012/02/car-suddenly-died-and-wont-start.html

Car is starting but not turning over?

http://technoanswers.blogspot.in/2012/02/car-is-starting-but-not-turning-over.html

Engine cranks but will not start?

http://technoanswers.blogspot.in/2012/02/engine-cranks-but-will-not-start.html

Exclamation indicator light on ford freestar dash?

http://technoanswers.blogspot.in/2012/02/exclamation-indicator-light-on-ford.html

2004 ford freestar van idles rough?

How to remove Intake Manifold Tuning Valve?

http://technoanswers.blogspot.com/2012/01/how-to-remove-intake-manifold-tuning.html

Trunk release Problem on Toyota Camry?

http://schematicsdiagram.blogspot.in/2012/02/trunk-release-problem-on-toyota-camry.html

CMFI details for GMC vehicles?

http://technoanswers.blogspot.com/2012/01/cmfi-details-for-gmc-vehicles.html

Mazda MPV cranks but will not start?

http://technoanswers.blogspot.com/2012/01/mazda-mpv-cranks-but-will-not-start.html

MAZDA MPV WILL CRANK BUT NOT TURN OVER TO START?

http://technoanswers.blogspot.com/2012/01/mazda-mpv-will-crank-but-not-turn-over.html

Freightliner fl112 fuse box diagram?

http://technoanswers.blogspot.com/2012/01/freightliner-fl112-fuse-box-diagram.html

Car will not turn the ignition to start?

http://technoanswers.blogspot.com/2012/01/car-will-not-turn-ignition-to-start.html

Car only starts when gas pedal is pressed?

http://technoanswers.blogspot.com/2012/01/car-only-starts-when-gas-pedal-is.html

How to compare pattern of left bank and right bank sensors?

http://schematicsdiagram.blogspot.in/2012/02/how-to-compare-pattern-of-left-bank-and.html

Check power train warning light on?

http://howtobyme.blogspot.in/2012/02/check-powertrain-warning-light-on.html

Check power-train message with orange engine light came on?

Check Powertrain message and Safety Mode Reduced Performance on Holden VZ Commodore?

http://howtobyme.blogspot.in/2012/02/check-powertrain-message-and-safety.html

Hyundai coupe f2 hazard fault?

http://schematicsdiagram.blogspot.com/2012/01/hyundai-coupe-f2-hazard-fault.html

No comments:

Post a Comment

@